MK6 Single or Dual GLI & Jetta pod install

1. Remove OEM vent cover with bone tool. Pry around the perimeter of the vent to slide it out. The tab nearest the windshield is the most difficult to remove.

2. Check behind doorjamb panel for wiring and dash supports before drilling at your own risk. We chose to drill here during our install.

3. Route wiring down the vent hole as needed.

4. Screw the base to the pod and mount your gauge.

5. We suggest running the long side of the adhesive pad along the front edge of the pod.

6. Most pods will friction fit and not require removal of the adhesive cover on the gauge side. A rubber band can also be used to friction fit the gauge inside the pod. Note: AEM X Series gauges come with a black rubber band that can be used instead of the adhesive pads.
7. Insert CJM Ind. vent base at an angle to seat the edge near the windshield.
Slide the pod back and seat the tab on the passenger side of the base. 

8. Press down on the outer front edge to snap in the base.  Do not press down on the vent fins. The pod can be rotated to get the best viewing angle.

 

For support email or text us!

support@cjmgear.com or 484-532-8433

Don’t forget to tag us and stay in touch!